The pitch of threads on a Jock nut in comparison to pitch of nut is_________________?

A. same
B. coarser
C. finer
D. very coarse
E. very fine

Related Mcqs:

For standard coarse threads of nut, the threads will be as strong in failure by shear as the bolt in tension, if the height of nut (h) is approximately________________?
A. 0.4 times B. 0.6 times C. 0.7 times D. 0.8 times E. 0.9 times the normal diameter of bolt...
If threads on a bolt are left hand, threads on nut will be_____________________?
A. right hand with same pitch B. left hand with same pitch C. could be left or right hand D. right hand with fine pitch E. left hand with fine pitch...
If shearing stress in nut is half the tensile stress in a bolt, then nut length should be equal to___________________?
A. diameter of bolt B. 0.75 x diameter of bolt C. 1.25 x diameter of bolt D. 1.5 x diameter of bolt E. 0.5 x diameter of bolt...
The included angle in unified of American National threads is___________________?
A. 60° B. 55° C. 47° D. 29° E. none of the above...
If an application calls for stresses on screw threads in one direction only, then the following type of thread would be best suited ________________?
A. square B. acme C. buttress D. BSW E. metric...
Buttress threads are usually found on____________________?
A. screw cutting lathes B. feed mechanisms C. spindles of bench vices D. screw jack E. railway carriage couplings...
When a nut is tightened by plaping a washer below it, the bolt will be subjected to following type of loads___________________?
A. compression B. tension C. shear D. combined loads E. all of the above...
Castle nut is a locking device in which__________________?
A. one smaller nut is tightened over main nut and main nut tightened against smaller one by loosening, creating friction jamming B. a slot is cut partly is middle of nut and then slot reduced by tightening a screw C. a hard fiber or nylon cotter is recessed in the nut and becomes threaded as...
Split nut is a locking device in which_________________?
A. one smaller nut is tightened over main nut and main nut tightened against smaller one by loosening, creating friction jamming B. a slot is cut partly in middle of nut and then slot reduced by tightening screw C. a hard fiber or nylon cotter is recessed in the nut and becomes threaded as the...
Elastic nut is a locking device in which__________________?
A. one small nut is tightened over main nut and main nut tightened against smaller one by loosening, creating friction jamming B. a slot is cut partly in middle of nut and then slot reduced by tightening a screw C. hard fiber or nylon cotter is recessed in the nut and becomes threaded as the...